HP 445942-001 manual Re-Mark Update User Priority configuration, Re-mark in-profile dot1p

Configuration Commands

Re-Mark Update User Priority configuration

The following table describes the Update User Priority Configuration commands.

Table 163 ACL Update User Priority Configuration commands

Command	Description
access-control list <1-384>	Defines 802.1p value. The value is the priority bits information in
re-mark in-profile dot1p <0-7>	the packet structure.
	Command mode: Global configuration
[no] access-control list <1-384>	Enable or disable mapping of TOS (Type of Service) priority to
re-mark in-profile use-tos-	802.1p priority for In-Profile packets. When enabled, the TOS
precedence	value is used to set the 802.1p value.
	Command mode: Global configuration
default access-control list	Resets UP1P settings to their default values.
<1-384> re-mark	Command mode: Global configuration
show access-control list <1-384>	Displays the current ACL re-mark parameters.
re-mark	Command mode: All except User EXEC

ACL Re-mark Out-of-Profile configuration

The following table describes the Re-mark Out-of-Profile Configuration commands.

Table 164 ACL Re-mark Out-of-Profile Configuration commands

Command	Description
access-control list <1-384>	Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the
re-mark out-profile dscp	selected value. The switch sets the DSCP value on Out-of-Profile packets.
<0-63>	Command mode: Global configuration
default access-control list	Resets the update DSCP parameters for Out-of-Profile packets to their
<1-384> re-mark	default values.
	Command mode: Global configuration
show access-control list	Displays the current ACL re-mark parameters.
<1-384> re-mark	Command mode: All except User EXEC

176