
Configuration Commands
802.1x Global configuration
The global 802.1x commands allow you to configure parameters that affect all ports in the switch (except management port 17). The following table describes the 802.1x Global Configuration commands.
Table 102 802.1x Global Configuration commands
Command | Description |
|
|
dot1x mode | Sets the type of access control for all ports: |
| • |
| |
| • |
| by the RADIUS server. |
| • |
| all traffic. |
| The default value is |
| Command mode: Global configuration |
|
|
dot1x | Sets the time, in seconds, the authenticator waits before transmitting |
| an |
| authentication failure in the previous round of authentication. The |
| default value is 60 seconds. |
| Command mode: Global configuration |
|
|
dot1x | Sets the time, in seconds, the authenticator waits for an EAP- |
| Response/Identity frame from the supplicant (client) before |
| retransmitting an |
| 30 seconds. |
| Command mode: Global configuration |
|
|
dot1x | Sets the time, in seconds, the authenticator waits for an EAP- |
Response packet from the supplicant (client) before retransmitting | |
| the |
| value is 30 seconds. |
|
|
dot1x | Sets the time, in seconds, the authenticator waits for a response |
| from the Radius server before declaring an authentication timeout. |
| The default value is 30 seconds. |
| Command mode: Global configuration |
|
|
dot1x | Sets the maximum number of times the authenticator retransmits an |
| |
| Command mode: Global configuration |
|
|
dot1x | Sets the time, in seconds, the authenticator waits before re- |
| authenticating a supplicant (client) when periodic |
| is enabled. The default value is 3600 seconds. |
| Command mode: Global configuration |
|
|
[no] dot1x | Sets the |
| off. |
| Command mode: Global configuration |
|
|
default dot1x | Resets the global 802.1x parameters to their default values. |
| Command mode: Global configuration |
|
|
127