HP 445942-001 Forwarding Database configuration, Static FDB configuration, 128, MAC address all

	Configuration Commands
Table 110 Spanning Tree Port Configuration commands
Command	Description
[no] spanning-tree stp	Enables or disables this port as an edge port. An edge port is not
{<1-128>} edge	connected to a bridge, and can begin forwarding traffic as soon as the
	link is up. Configure server ports as edge ports (enabled).
	This command only applies when RSTP is turned on. See the “Common
	Internal Spanning Tree configuration” section for more information.
	Command mode: Interface port
spanning-tree stp {<1-128>}	Enables or disables Port Fast Forward on the port.
fastforward	Command mode: Interface port
spanning-tree stp {<1-128>}	Enables STP on the port.
enable	Command mode: Interface port
no spanning-tree stp	Disables STP on the port.
{<1-128>} enable	Command mode: Interface port
show interface port {<port	Displays the current STP port parameters.
number>} spanning-tree stp	Command mode: All
{<1-128>}

Forwarding Database configuration

The following table describes the Forwarding Database Configuration commands.

Table 111 FDB Configuration commands

Command	Description
aging <0-65535>	Configures the aging value for FDB entries. The default value is 300.
show mac-address-table	Displays current FDB parameters.

Static FDB configuration

The following table describes the Static FDB Configuration commands.

Table 112 Static FDB Configuration commands

Command	Description
mac-address-table static	Adds a static entry to the forwarding database.
[<MAC address> vlan <VLAN>	Command mode: Global configuration
port <port>]
no mac-address-table static	Deletes a static entry from the forwarding database.
[<MAC address> all]	Command mode: Global configuration

137