activated, you can dial a fax number without the dial prefix by using manual dial. For instructions, see Manual dial faxing on page 138.

1.On the control panel, press Setup.

2.Use the arrow buttons to select Fax setup, and then press OK.

3.Use the arrow buttons to select Basic setup, and then press OK.

4.Use the arrow buttons to select Dial Prefix, and then press OK.

5.Use the arrow buttons to select On or Off, and then press OK.

6.If you selected On, use the alphanumeric buttons to enter the prefix, and then press OK. You can use numbers, pauses, and dialing symbols.

Set the dial-tone detection

Normally, the product begins dialing a fax number immediately. If you are using the product on the same line as your telephone, turn on the detect-dial-tone setting. This prevents the product from sending a fax while someone is on the telephone.

The factory-set default for detect dial tone is On for France and Hungary, and Off for all other countries/ regions.

1.On the control panel, press Setup.

2.Use the arrow buttons to select Fax setup, and then press OK.

3.Use the arrow buttons to select Advanced setup, and then press OK.

4.Use the arrow buttons to select Detect dial tone, and then press OK.

5.Use the arrow buttons to select On or Off, and then press OK.

Set autoredial

If the product was unable to send a fax because the receiving fax machine did not answer or was busy, the product attempts to redial based on the redial-on-busy, redial-on-no-answer, and redial-on- communication-error options. Use the procedures in this section to turn these options on or off.

Set the redial-on-busy option

If this option is turned on, the product redials automatically if it receives a busy signal. The factory-set default for the redial-on-busy option is On.

1.On the control panel, press Setup.

2.Use the arrow buttons to select Fax setup, and then press OK.

3.Use the arrow buttons to select Advanced setup, and then press OK.

4.Use the arrow buttons to select Redial if busy, and then press OK.

5.Use the arrow buttons to select On or Off, and then press OK.

124 Chapter 12 Fax (fax models only)

ENWW

Page 136
Image 136
HP CM2320 manual Set the dial-tone detection, Set autoredial, Set the redial-on-busy option