HP CM2320 Paper setup Default paper size Letter, Does not specify a size, Cancel, Tray is empty

Table 2-5System setup menu (continued)

Menu Item	Sub-menu item	Sub-menu item	Description
Paper setup	Default paper size	Letter	Sets the size for printing internal reports or any print job that
		A4	does not specify a size.
		Legal
	Default paper type	Lists available	Sets the type for printing internal reports or any print job that
		media types.	does not specify a type.
	Tray 1	Paper type	Sets the default size and type for tray 1.
		Paper size
	Paper out action	Wait forever	Determines how the product reacts when a print job requires
		Cancel	a media size or type that is unavailable or when a specified
			tray is empty.
		Override	● Select Wait forever to make the product wait until the
				correct media is loaded.
			● Select Override to print on a different size paper after
				a specified delay.
			● Select Cancel to automatically cancel the print job after
				a specified delay.
			● If either Override or Cancel is chosen, the control
				panel prompts for the number of seconds to delay. Use
				the arrow keys to either decrease the time or increase
				the time up to 3600 seconds.
Print quality	Calibrate Color	Calibrate Now	Perform a Color Pane Registration (CPR) and density
		After Power On	calibration. Select Calibrate Now to perform an immediate
			calibration. Select After Power On to specify the minutes/
			hours the product should wait after power on to perform an
			automatic calibration (the default is 15 minutes).
	Cartridge low	(Range of 1-20)	Sets the percentage at which the control panel generates a
	threshold		low-toner message.
	Replace supplies	Stop at Out	Sets how the product reacts when it detects that the print
		Override out	cartridge is out.
	Color supply out	Stop printing	Sets how the product should react when it detects that a
		Continue black	color cartridge is empty. Select Stop printing to stop all
			printing until the cartridge is replaced, or select Continue
			black to continue printing in black monochrome mode.
Adjust Alignment	Print Test Page		Print out a tray-specific sheet of instructions and a test page
(photo card models			with a border that can be used to estimate the adjustment
only)			needed to center the printed image on the page.
	Adjust Tray 1		After printing the test page, use the options in the Adjust
			Tray 1 menu to calibrate the tray. The following settings can
			be adjusted for Tray 1:
			●	X1 Shift
			●	Y Shift

ENWW Control-panel menus 17