FIGURE 67. Screen Shot: Select Images to Install

STEP 9. Select the recovery image to install. The correct filename has the form FLARE-aa.bb.ccc.d.eee.mif.

CAUTION

If there is no filename with the form FLARE-aa.bb.ccc.d.eee.mif, then no recovery image exists. You cannot continue with this procedure until you have obtained a recovery image. See Procedure 33, "Using FTP to Obtain and Store an SP Boot Image," on page 179.

After you have specified an image, the software displays the Confirm Image Installation screen.

STEP 10. Enter y if the image selection is correct. The software then displays the Select Storage Processors to Install screen.

STEP 11. Select This SP as the SP you want to recover because it is the SP you physically connected with the serial cable.

For example, if you are restoring the image to SP B, select SP B only. Do not try to restore images to both SPs in one procedure.

After you have selected an SP, the software copies the image to the boot drives of that SP. It displays a screen that shows the percentage copied, similar to the one shown in Figure 68. The copy may take up to 10 minutes.

176

Intel Storage System SSR212PP User Guide

 

Revision 1.0

Page 190
Image 190
Intel SSR212PP manual Screen Shot Select Images to Install