Juniper Networks EX8208 manual Adjustable Mounting Brackets for Four-Post Rack Installation

Complete Hardware Guide for EX8208 Ethernet Switches

Figure 41: Adjustable Mounting Brackets for Four-Post Rack Installation

6.Position the right front adjustable mounting bracket at the desired position in the right side of the rack opposite the installed left front bracket, so that it is on the same rack level as the left bracket. If the right and left front brackets are not on the same level, the chassis will rest at an angle in the rack instead of resting flat and level. Line up the right bracket's front screw holes with the holes in the rack. Use 4 mounting screws appropriate for your rack to attach the right front bracket to the rack.

7.Position the other rear bracket at the right rear of the rack on the same level as the right front bracket, so that the rear bracket overlaps with the right front bracket. The screw holes for connecting the front and rear brackets should overlap. Use 4 mounting screws appropriate for your rack to attach the rear bracket to the rack.

8.Connect the right front and rear brackets (see Figure 41 on page 134):

a.Insert 6 of the screws provided with the mounting brackets into the overlapping bracket holes.

b.Hand tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips screwdriver.

134 Copyright © 2010, Juniper Networks, Inc.