Juniper Networks EX8208 manual Copyright 2010, Juniper Networks, Inc 141

Chapter 8: Installing the Switch

Mounting an EX8208 Switch on a Rack or Cabinet Using a Mechanical Lift

Because of the switch's size and weight, we strongly recommend using a mechanical lift to install the switch.

NOTE: For instructions on installing a switch without using a mechanical lift, see “Mounting an EX8208 Switch on a Rack or Cabinet Without Using a Mechanical Lift” on page 143.

CAUTION: Do not install line cards in the chassis until after you mount the chassis securely on a rack or cabinet.

CAUTION: Before front-mounting the switch on a rack or cabinet, have a qualified technician verify that the rack or cabinet is strong enough to support the switch's weight and is adequately supported at the installation site.

Before you install the switch:

•Prepare the site for installation as described in “Site Preparation Checklist for an EX8200 Switch” on page 91.

•Ensure the site has adequate clearance for both airflow and hardware maintenance as described in “Clearance Requirements for Airflow and Hardware Maintenance for an EX8208 Switch” on page 101.

•Unpack the switch as described in “Unpacking an EX8200 Switch” on page 126.

•In a two-post rack, install the power cord tray at the desired position (see “Installing the Power Cord Tray in a Rack or Cabinet for an EX8200 Switch” on page 135). The lip of the power cord tray will support the front of the chassis when you install the switch in the two-post rack.

•In a four-post rack, install the adjustable mounting brackets at the desired position (see “Installing Adjustable Mounting Brackets in a Rack or Cabinet for an EX8200 Switch” on page 132). Optionally, you can also install the power cord tray and use it to manage the power supply cords.

•Review chassis lifting guidelines described in “Chassis Lifting Guidelines for EX8200 Switches” on page 276.

Ensure that you have the following parts and tools available to install the switch:

•A mechanical lift

•24 mounting screws appropriate for your rack

•A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your rack mounting screws

Copyright © 2010, Juniper Networks, Inc. 141