Juniper Networks EX8208 Performing Initial Configuration, EX8200 Switch Default Configuration

CHAPTER 11

Performing Initial Configuration

•EX8200 Switch Default Configuration on page 189

•Connecting and Configuring an EX Series Switch (CLI Procedure) on page 190

•Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 192

EX8200 Switch Default Configuration

Each EX8200 switch is programmed with a factory default configuration that contains the values set for each configuration parameter when a switch is shipped. The default configuration file sets values for system parameters such as the ARP aging timer, the system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol, IGMP snooping, and storm control.

When you commit changes to the configuration, a new configuration file is created that becomes the active configuration. You can always revert to the factory default configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.

This topic shows the factory default configuration file of an EX8200 switch:

system { arp {

aging-timer 5

}

}

syslog { user * {

any emergency;

}

file messages { any notice; authorization info;

}

file interactive-commands { interactive-commands any;

}

}

commit { factory-settings {

reset-chassis-lcd-menu;

}

}

Copyright © 2010, Juniper Networks, Inc. 189