Juniper Networks EX8208 manual LCD Panel Menus, LCD Panel Menu Options for the EX8200 Switch

Chapter 2: Component Descriptions

The maintenance mode allows you to cycle through options for configuring and troubleshooting the switch:

•System halt

•Reboot system

•Load rescue configuration

•Revert to factory configuration

•EZSetup

LCD Panel Menus

The LCD has three menus: Idle, Status, and Maintenance. In each of these menus, line one of the LCD panel displays the hostname of the switch. Toggle between the LCD menus by pressing the Menu button. Navigate through the menu options by pressing the Enter button.

Table 7 on page 19 describes the LCD menu options.

Table 7: LCD Panel Menu Options for the EX8200 Switch

Menu Description

Idle In the Idle menu:

•Press Enter to cycle through the Status LED modes, which are port status indicators:

•ADM (enabled/disabled)

•SPD (speed)

•DPX (duplex)

See “Network Port LEDs in an EX8200 Switch” on page 37 for information on the Status LED.

•Press Menu to exit the Idle menu and go to the Status menu.

Copyright © 2010, Juniper Networks, Inc. 19