Juniper Networks EX8208 manual Copyright 2010, Juniper Networks, Inc

Complete Hardware Guide for EX8208 Ethernet Switches

The configured parameters are displayed. Enter yes to commit the configuration.

The configuration is committed as the active configuration for the switch. You can now log in with the CLI or the J-Web interface to continue configuring the switch. If you use the J-Web interface to continue configuring the switch, the Web session is redirected to the new management IP address. If the connection cannot be made, the J-Web interface displays instructions for starting a J-Web session.

Related Topics • Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 192

•Installing and Connecting an EX2200 Switch

•Installing and Connecting an EX3200 or EX4200 Switch

•Installing and Connecting an EX4500 Switch

•Installing and Connecting an EX8208 Switch on page 125

•Installing and Connecting an EX8216 Switch

Connecting and Configuring an EX Series Switch (J-Web Procedure)

There are two ways to connect and configure an EX Series switch: one method is through the console using the CLI and the other is using the J-Web interface. This topic describes the J-Web procedure.

NOTE: Before you begin the configuration, enable a DHCP client on the management PC you will connect to the switch so that the switch can obtain an IP address dynamically.

NOTE: Read the following steps before you begin the configuration. You must complete the initial configuration using EZSetup within 10 minutes. The switch exits EZSetup after 10 minutes and reverts to the factory default configuration, and the PC loses connectivity to the switch.

•EX2200 switch—The LEDs on the network ports on the front panel blink when the switch is in the initial setup mode.

•EX3200,EX4200,EX4500,orEX8200switch—TheLCDdisplaysacount-downtimer when the switch is in initial setup mode.

192 Copyright © 2010, Juniper Networks, Inc.