Juniper Networks EX8208 manual Removing a Line Card with a 2-in. Ejector Lever

Complete Hardware Guide for EX8208 Ethernet Switches

7.Grasp the ejector levers and gently slide the line card halfway out of the chassis (see Figure 89 on page 220 and Figure 90 on page 220).

Figure 89: Removing a Line Card with a 2-in. Ejector Lever

Captive screw

Ejector levers

g020906

Figure 90: Removing a Line Card with a 4-in. Ejector Lever

See “Handling and Storing Line Cards in EX8200 Switches” on page 227.

CAUTION: Do not lift the line card by holding the ejector levers on the faceplate or the edge connectors. The levers cannot support the weight of the line card. Lifting the line cards by the levers might bend them. Bent levers prevent the line cards from being properly seated in the chassis.

CAUTION: Do not stack line cards on top of one another or on top of any other component. Place each line card separately in the antistatic bag or on the antistatic mat placed on a flat, stable surface.

CAUTION: The line cards in EX8200 switches weigh more than 10 lb (4.5 kg). Be prepared to support the full weight as you slide the line card out of the chassis.

8.Place one hand around the faceplate of the line card and the other hand under the line card to support it. Taking care not to touch line card components, pins, leads, or solder connections, gently slide the line card completely out of the chassis and place it in an antistatic bag or on its own antistatic mat placed on a flat, stable surface.

220 Copyright © 2010, Juniper Networks, Inc.