Juniper Networks EX8208 manual Connecting and Configuring an EX Series Switch CLI Procedure

Complete Hardware Guide for EX8208 Ethernet Switches

}

protocols { igmp-snooping {

vlan all;

}

lldp { interface all;

}

rstp;

}

ethernet-switching-options { storm-control {

interface all;

}

}

Related Topics • Configuration Files Terms

•Connecting and Configuring an EX Series Switch (CLI Procedure) on page 190

•Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 192

•Understanding Configuration Files for EX Series Switches

•EX8208 Switch Hardware Overview on page 3

•EX8216 Switch Hardware Overview

Connecting and Configuring an EX Series Switch (CLI Procedure)

There are two ways to connect and configure an EX Series switch: one method is through the console using the CLI and the other is using the J-Web interface. This topic describes the CLI procedure.

NOTE: To run the ezsetup script, the switch must have the factory default configuration as the active configuration. If you have configured anything on the switch and want to run ezsetup, revert to the factory default configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.

Before you begin connecting and configuring an EX Series switch through the console using the CLI:

•Set the following parameter values in the console server or PC:

•Baud Rate—9600

•Flow Control—None

•Data—8

•Parity—None

190 Copyright © 2010, Juniper Networks, Inc.