Chapter 11: Performing Initial Configuration
To connect and configure the switch using the
1.Transition the switch into initial setup mode:
•EX2200
•EX3200, EX4200, EX4500, or EX8200
Figure 78: LCD Panel in an EX3200, EX4200, EX4500, or EX8200 Switch
1.Press the Menu button until you see MAINTENANCE MENU. Then press the Enter button.
2.Press Menu until you see ENTER EZSetup. Then press Enter.
If EZSetup does not appear as an option in the menu, select Factory Default to return the switch to the factory default configuration. EZSetup is displayed in the menu only when the switch is set to the factory default configuration.
3.Press Enter to confirm setup and continue with EZSetup.
2.Connect the Ethernet cable from the Ethernet port on the PC to the switch.
•EX2200, EX3200, or EX4200
•EX4500
•EX8200
These ports are configured as the DHCP server with the default IP address, 192.168.1.1. The switch can assign an IP address to the management PC in the IP address range 192.168.1.2 through 192.168.1.253.
3.From the PC, open a Web browser, type http://192.168.1.1 in the address field, and press Enter.
4.On the
5.On the Introduction page, click Next.
6.On the Basic Settings page, modify the hostname, the root password, and date and time settings:
Copyright © 2010, Juniper Networks, Inc. | 193 |
