Juniper Networks manual SF Module LEDs in an EX8208 Switch

Chapter 2: Component Descriptions

In the base configuration, an SF module is used with a single Switch Fabric and Routing Engine (SRE) module to build a nonredundant system that provides full bandwidth. However, a base configuration EX8208 switch has no Routing Engine and switch control redundancy or switch fabric redundancy. In a base configuration, the main function of the SF module is to switch data between line cards. See “Understanding EX8208 Switch Component and Functionality Redundancy” on page 11.

In a redundant configuration, an SF module is used with two SRE modules to achieve full bandwidth along with Routing Engine and switch control redundancy and switch fabric redundancy. In a redundant configuration, the main function of the SF module is to provide a redundant switching plane for the switch. See “Understanding EX8208 Switch Component and Functionality Redundancy” on page 11.

In a redundant configuration, the SF module is hot-pluggable. However, in the base configuration, you must take the SF module offline before removing it.

The SF module contains logic that determines which SRE module is the master. The master SRE module controls many internal functions of the SF module.

The SF module provides these functions:

•Provide redundant data path connectivity for the switch in the redundant configuration

•Provide nonredundant data path connectivity for the switch in the base configuration

The SF module has these components:

•SF module LEDs—Indicate system status. See “SF Module LEDs in an EX8208 Switch” on page 29.

•Ejector levers—Used for installing and removing the SF module.

•Captive screws—Secure the SF module in place.

Related Topics • Installing an SF Module in an EX8208 Switch on page 157

•Removing an SF Module from an EX8208 Switch on page 217

•Taking the SF Module Offline in an EX8208 Switch on page 216

SF Module LEDs in an EX8208 Switch

The Switch Fabric (SF) module has two LEDs on the left side of the module’s front panel. See Figure 11 on page 30.Table 13 on page 30 describes these LEDs, their colors and states, and the status they indicate.

Copyright © 2010, Juniper Networks, Inc. 29