Juniper Networks EX8208 manual Copyright 2010, Juniper Networks, Inc

Complete Hardware Guide for EX8208 Ethernet Switches

adjustable mounting brackets ensure that the holes in the front-mounting brackets attached to the chassis align with the holes in the rack rails.

In a two-post rack, carefully slide the switch over the lip of the power cord tray and into the rack. Push the bottom of the chassis so that the front-mounting bracket is flush with the front of the rack.

5.Install a mounting screw into each of the open front-mounting holes aligned with the rack, starting from the bottom.

6.Visually inspect the alignment of the chassis. If the chassis is installed properly in the rack, all the mounting screws on one side of the rack are aligned with the mounting screws on the opposite side and the switch is level.

7.After ensuring that the switch is aligned properly, tighten the screws.

Figure 50: Installing an EX8208 Switch in a Four-Post Rack

146 Copyright © 2010, Juniper Networks, Inc.