2
2-122 McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual
Installation Tasks
• Click Enable to activate the CLI. The message Your changes
to the CLI enable state have been successfully activated
appears.
• Click Disable to deactivate the CLI. The message Your changes
to the CLI enable state have been successfully activated
appears.
Enable or Disable
Host Control Perform this procedure to toggle (enable or disable) host control of
the switch through the OSMS. The OSMS feature must be installed to
access this control. Refer to Install PFE Keys (Optional) on page 2-132
for instructions. If the feature is not installed, the message OSMS
Feature Not Installed appears. To enable or disable host control:
1. At the Configure panel, click the OSMS tab. The Management page
displays with the OSMS tab selected (Figure 2-98).
Figure 2-98 Configure Panel (Management Page with OSMS Tab)
2. Perform one of the following steps as required:
• Click Enable to activate the OSMS. The message Your changes
to the host control enable state have been successfully
activated appears.
• Click Disable to deactivate the OSMS. The message Your
changes to the host control enable state have been
successfully activated appears.