McDATA 3032, 3232 FRU Removal and Replacement, Remove and Replace FRUs

FRU Removal and Replacement 5-1

FRU Removal and

This chapter describes the removal and replacement procedures

(RRPs) for the Sphereon 3032/3232 field-replaceable units (FRUs). Do

not remove a FRU until a failure is isolated to that FRU. If fault

isolation was not performed, refer to MAP 0000: Start MAP on

page 3-6.

This section describes procedures to remove and replace (RRP)

concurrent Sphereon 3032/3232 FRUs. A flat-blade screwdriver is

required to remove and replace the fan FRUs. No tools are required to

remove and replace the other FRUs. All FRUs are removed and

replaced while the switch is powered on and operational (concurrent

FRUs). Refer to Chapter 6, Illustrated Parts Breakdown for FRU

locations and part numbers.

FRUs Table 5-1 lists the FRUs and electrostatic discharge (ESD) precaution

requirements (yes or no) for each FRU.

Table 5-1 ESD Requirements

FRU Name ESD Precaution Requirement

SFP LC transceiver No

Power supply No

Cooling fan No