McDATA 3032, 3232 Configure Fabric Binding

2
Task 25: Configure the Switch from the SANpilot Interface (Optional) 2-127
Installation Tasks
Configure Fabric
Binding Perform this procedure to configure fabric binding by attached fabric
member (domain ID and WWN). The SANtegrity feature must be
installed to access this control. Refer to Install PFE Keys (Optional) on
page 2-132 for instructions. If the feature is not installed, the message
This Feature Not Installed appears. To configure fabric binding:
1. At the Configure panel, click the Fabric Binding tab. The Security
page displays with the Fabric Binding tab selected (Figure 2-102).
Figure 2-102 Configure Panel (Security Page with Fabric Binding Tab)
2. The saved status of the fabric binding configuration displays at
the top of the page. The status can be:
•Saved & Active - Information displayed on the page reflects
the active configuration saved for the fabric.
•Unsaved & Active - Information displayed may be different
than the active configuration saved for the fabric.