McDATA 3032, 3232 Tools and Test Equipment

1-46 McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual

General Information

•warmStart - reports that the SNMP agent is reinitializing due to a

switch IPL.

•authorizationFailure - reports access by an unauthorized SNMP

manager. This trap is configurable, and is disabled by default.

Switch-specific SNMP traps specified in the custom MIB include

Fibre Channel port operational state changes and FRU operational

state changes.

If authorized through the Configure SNMP dialog box in the Element

Manager application, users at SNMP management workstations can

modify MIB variables. Switch modifications performed through

SNMP management work stations are recorded in the associated

Sphereon 3032/3232 Audit Log and are available through the Element

Manager application.

For additional information, refer to the McDATA OPENconnectors

SNMP Support Manual (620-000131).

Call-Home Support If e-mail notification and call-home support are configured for the

switch as part of the customer support process, service personnel

may be:

• Notified of a switch problem by e-mail message, either directly or

through a system administrator at the customer site or call center.

• Assigned a service call from call center personnel upon receipt

and confirmation of a switch call-home event.

NOTE: The call-home feature may not be supported on customer-supplied

server platforms.

Tools and Test Equipment

This section describes tools and test equipment that may be required

to install, test, service, and verify operation of the switch and

attached management server. These tools are supplied with the

switch or must be supplied by service personnel.

the Switch The following tools are supplied with the switch. Use of the tools

may be required to perform one or more installation, test, service, or

verification tasks.