Muratec F-360 manual Programming a broadcast

SPEED DIAL/GROUP and the number’s

Advanced features

Programming a broadcast

Programming a broadcast is very similar to programming a delayed transmission. But instead of sending to just one phone number, you set up multiple numbers for the transmission.

To program a broadcast into a programmable one-touch key:

1 Press MENU, 3, 4, 0, 1, ENTER. The LCD shows the first empty programmable one-touch number available:

2 Select the programmable one-touch key in which you want to program or change.

Note: You can select the programmable one-touch key by pressing that key on the control panel.

Note: If you’re changing a previously stored command: If your previous com- mand for this key was for a broadcast operation, and you want to keep this key programmed for a broadcast operation, use these instructions to make changes. But if you want to assign this key to a completely different operation, for example, a document storage operation, then you must first erase the stored command before programming the new one.

3 Press ENTER. The LCD asks which operation you want to program into the pro- grammable one-touch:

Note: If changing a previously stored command, skip to step 7.

4 Using the cursor key, select “Communication” and press ENTER. The LCD shows:

5 Use the numeric keypad to enter up to 330 fax numbers — you can use any combination of call groups, one-touch keys, speed-dial numbers and manually- dialed numbers.

To enter a speed-dial number, press three-digit identifier.

To enter a call group, press SPEED DIAL/GROUP twice and the group’s identifier number.

To add more fax numbers, press BROADCAST. Then enter the next number.

Note: If you want to review the numbers you entered, press [Review].

When you finish to review, press [Return] to return to the previous display.

6 When you enter all numbers you want, press ENTER. The LCD shows:

7 If you want the polling to begin immediately every time you press the key, proceed to step 8.

If you want to delay the polling, follow steps 7–9 on page 3.39.

8 Select “Exit” and press ENTER. The LCD shows:

The LCD asks if you want to make option settings which includes; resolution, contrast, memory transmission, report, cover page and Fax & Copy. If you want to make any of these settings, select ON using the cursor key.

3.40