Muratec F-360 Security features, Passcode, Security reception, Activating security reception

Advanced features

Security features

Your machine has a number of security features to keep your private fax documents private, avoid unwanted outside communication and even protect against unautho- rized use of your machine.

These security features include:

(1)Security reception, (2) PIN mask, (3) Block junk fax, and (4) Department codes.

The passcode

Your machine has a passcode protection system which must be turned on in order to use the security features listed below:

•Security reception

•PIN mask

•Department code protection To set your machine’s passcode:

1	Decide on the four-digit passcode (0001–9999)you want to use. Write it down,
	and put it in a safe place.
	Important: Do not use 0000. This turns off passcode protection.
2	Press MENU, 2, 1, 0, 2, ENTER.
	If you are creating a passcode, skip to step 5.
	If you are changing an existing passcode, proceed to step 3.
3	The LCD shows:

4	Use the numeric keypad to enter the existing passcode. Then press ENTER.
5	The LCD shows:

6 Enter the new four-digit passcode. Then press ENTER to save the passcode.

Note: Any time you want to turn off the passcode, change the passcode back to 0000 by repeating steps 2–6 and entering 0000 in step 6.

Security reception

Security reception tells your machine to keep all received faxes in memory (but not print them). Then you can print them out later, at your convenience. For example, you could use this if you’re concerned about workers reading documents intended for your eyes only.

Important: For this feature to work, you must have activated the passcode protec- tion as described on left column. You must also know the passcode.

Note: In the following instructions, your machine’s LCD shortens the word Transmission to Tx and the word Receive to Rx.

Activating security reception

1 Press MENU, 2, 2, 1, 1, ENTER. The LCD shows:

2 Use the numeric keypad to enter the protection passcode.

3 Press ENTER. The LCD shows:

3.46