Muratec F-360 manual Settings for transmission, Scan settings

Select contrast mode you want to set using the cursor key, then press ENTER.

Settings for transmission

Scan settings

Default setting: Primary resolution: Normal, Primary contrast: Normal, Scan

width: B4

Three different settings tell your machine how to scan documents. The initial fac- tory settings are probably right for most applications, so try using them before changing any of these settings:

•Primary resolution mode — Sets the resolution for your documents. Choose either normal, fine, superfine (“S-Fine” on the LCD) or grayscale mode (“Gray”).

•Primary contrast mode — Sets how light or dark you want faxed documents to be when they arrive at their destinations.

•Scan width — Sets the scan width for your documents. Choose either B4 or A4.

Note: These settings you choose effect your fax activity only.

To set these modes:

1 Press MENU, 2, 2, 0, 1, ENTER. The LCD shows:

2 To set the primary resolution mode, select “Primary Resolution” and then press ENTER. The LCD will show:

3 Select resolution mode you want to set using the cursor key, then press

ENTER.

Changing the default settings

4 To set the primary contrast mode, select “Primary Contrast” and then press ENTER. The LCD will show:

5

6 To set the primary scan width, select “Scan Width” and then press ENTER. The LCD will show:

7	Select scan width you want to set using the cursor key, then press ENTER.
8	When you finished your choice, select “Exit” and then press ENTER to save
	the settings.

By following the steps above, you’ve set your defaults for scanning. Before sending documents, you can “override” these default scan settings for that transmission.

To override the default resolution and contrast settings before sending a document:

•Press [Mode] to change the resolution.

•Press [Contrast] to change the contrast.

Once your document is transmitted, your machine returns to its default settings.

4.1