Muratec F-360 manual Copy print settings, Print margin, Bypass Tray priority

Copy print settings

You can set three print parameters for copy:

•Print reduction rate for copy

•Print margin for copy

•Bypass Tray priority

You set these three in the same procedure, discussed below. Following is an explana- tion for each:

Print reduction rate

Copy reduction lets you set the machine to reduce large documents to a size that fits the paper in your machine. (This setting doesn’t affect printing fax message you may receive with your machine.)

Print margin

Your machine’s print margin for copying is measured in millimeters (mm). We’ll define print margin by explaining how it’s used:

When an original document is scanned, the machine measures the document’s length and compares it to: (a) the length of your selected paper (not include the print margins) plus (b) the print margin you set. If the length of the document is longer than (a) and (b) put together, your machine prints the document on more than one sheet.

Note: A print margin setting of 24 mm will print most documents as single pages. Try this combination first and then, only if you have problems with it, select different settings.

Bypass Tray priority

If you set the same sized paper to both the paper cassette and bypass tray, and this mode is turned to on, the machine gives priority to use the paper which is set on the bypass tray than the paper in the cassette.

To adjust the copy print settings

Default setting: Copy reduction rate: 100%, Margin: 24 mm,

Bypass tray priority: Off

1 Press MENU, 2, 3, 0, 2, ENTER. The LCD shows the current print margin for copying:

		Changing the default settings
2	To set the reduction rate for copying, select “Reduction Ratio” using the
	cursor key and then press ENTER. The LCD will show:

3 Using the cursor key to select Auto, 100% or 78% for the copy reduction set- ting. Then press ENTER.

4 To set the reduction margin for copying, select “Reduction Margin” using the cursor key and then press ENTER. The LCD will show:

5	Use the numeric keypad to enter the print margin you want, from 00 to 85.
	Then press ENTER.
	Note: Enter a leading zero when entering a quantity less than 10.
6	To set the bypass tray priority, select “Bypass Tray Priority” using the cur-
	sor key and then press ENTER. The LCD will show:

In case of the same size papers are set in the cassette and on the bypass tray, the cassette has a priority to supply papers. If you want the bypass tray to have a priority, select ON.

7 Using the cursor key to select “ON” or “OFF” for the bypass tray priority set- ting. Then press ENTER.

8 When you finished the setting, select “Exit ” and then press ENTER to save the settings.

4.7