NCT Group NCT 100T Is displayed Y=yes. By pressing Shift key question, Restore Modal FUNCTIONS? N

13 Interruption and Restart of Automatic Operation

if machining is started in INTD state of automatic mode and START button is pressed, control registers STOP state and message

RESTORE MODAL FUNCTIONS? Y

is displayed (Y=yes). By pressing <SHIFT> key question

RESTORE MODAL FUNCTIONS? N

is asked (N=no). The messages can be switched over by the use of <SHIFT> key . If the

START button is pressed, it restores the state before suspension according to the

message (Y) or not (N). The message is canceled with the help of the RESET key and INTD state remains.

Modal information restated or not restated:

–modal G codes,

–value F,

–compensation code: T__nn,

–modal parameters of canned cycles (start level, R level ect).

After restart has been made from INTD state the work zero point offsets and tool compen- sation values altered always taken into consideration.

102