NCT Group NCT 2000T, NCT 100T, NCT 990T manual 140

14.3Listing of Global Messages

Error		Message		Description	Canceling and Re-
Code					pairing Method
3508	NC STATUS TABLE BAD			If the check sum of the memory area con-	The message is can-
				taining the general NC state, preserved	celed by RESET
				upon power-off is false.	key.
				These data are as follows:	The listed data must
				G20/G21: inch/metric input;	be reorganized.
				the number of registered tool length
				compensation (H), and the axis, on which
				it is valid;
				the programs selected for automatic or
				MDI execution;
				DNC state;
				if the power is turned off during program
				execution, the program number, the
				execution of which, was interrupted.
3509	LIFE TIME TABLE BAD			If the check sum of the memory area con-	The message is can-
				taining the life time table, preserved upon	celed by RESET
				power-off is false.	key.
					The life time table
					must be reorganized.
3510	TOOL	OFFSET	TABLE	If the check sum of the memory area con-	The message is can-
	BAD			taining the tool offset table, preserved	celed by RESET
				upon power-off is false.	key.
					The tool offset table
					must be reorganized.
3511	WORK	OFFSET	TABLE	If the check sum of the memory area con-	The message is can-
	BAD			taining the work zero point offset table,	celed by RESET
				preserved upon power-off is false.	key.
					The work zero point
					offsets must be meas-
					ured again.
3514	OVERRUN ERROR			This message is displayed if in DNC oper-	The message is can-
				ation during serial transfer two bytes over-	celed by RESET
				run without the previous one being read	key.
				by the control.	Loading must be re-
					started.
3515	PARITY ERROR			If in DNC operation through the serial	The message is can-
				interface, the control receives data of	celed by RESET
				incorrect parity . This message is also dis-	key.
				played as a result of different parameter	Loading must be
				settings on the transmitter and receiver	restarted.
				side.
3516	FRAMING ERROR			It occurs in DNC operation. Framing error	The message is can-
				is due to different parameter settings on	celed by RESET
				the transmitter and receiver side.	key.
				These are as follows:	Loading must be re-
				baud rate,	started.
				word length,
				the number of stop bits.

140