NCT Group NCT 990T, NCT 100T, NCT 2000T manual 130

14.3Listing of Global Messages

Error	Message		Description	Canceling and Re-
Code				pairing Method
3006	VALUE EXCESS H, D, P		If in tool offset selection (H) or (D) the	The message is can-
			number entered under the address exceeds	celed by RESET
			the range permitted.	key.
			The same error occurs in case of value P
			of command G10 L(10, 11, 12, 13).
3007	G43, G44, H IN G2, G3		If in a block containing circular interpola-	The message is can-
			tion (G2, G3) tool length offset is pro-	celed by RESET
			grammed (G43, G44, H)	key.
3008	ERRONEOUS G45...G48		If radius compensation code (D) is chang-	The message is can-
			ed when using G45...G48 or	celed by RESET
			the use of code G45...G48 results in con-	key.
			flict.
3009	G45...G48 IN G41, G42		If code G45...G48 is used when G41 or	The message is can-
			G42 is switched on.	celed by RESET
				key.
3010	PLANE SELECT. IN G41,		If plane selection (G17, G18, or G19) is	The message is can-
	G42		programmed in offset mode (G41, G42).	celed by RESET
				key.
3011	RADIUS DIFFERENCE		If the difference between the start point	The message is can-
			radius and the end point radius of a circu-	celed by RESET
			lar arc exceeds the value specified in pa-	key.
			rameter 1021 RADDIF.
3012	ERRONEOUS	CIRCLE	If in circular interpolation definition (G2,	The message is can-
	DEF. R		G3) radius (R) had been specified and the	celed by RESET
			start point and end point coincide.	key.
3013	MULTITURN	CIRCLE	If at multiturn circle definition (polar	The message is can-
	FAILURE		coordinate specification G16 is on) the	celed by RESET
			polar angle change is	key.
			not negative in case of G2 or
			not positive in case of G3.
3014	ERRONEOUS	CIRCLE	If when programming circular interpola-	The message is can-
	DEF.		tion (G2, G3) neither the radius (R) nor	celed by RESET
			the center coordinate (I, J, K) is defined,	key.
			or
			the specification of center coordinates
			conflicts with the selected plane (G17: I,
			J; G18: I, K; G19: J,K).
3015
3016	FORBIDDEN ADDRESS		If an address has been referred to in the	The message is can-
			program that is forbidden or conflicting in	celed by RESET
			that situation.	key.
3017	,C AND ,R IN ONE BLOCK		If chamfering (,C) and corner round (,R)	The message is can-
			have been programmed in the same block.	celed by RESET
				key.

130