NCT Group NCT 990T, NCT 100T, NCT 2000T manual 124

14.3Listing of Global Messages

Error	Message	Description	Canceling and Re-
Code			pairing Method
60	PLC TIMEOUT 1	If either module :001 or module :002 of	This message can
		PLC program does not expire in the time	only be canceled by
		slice reserved for it, message PLC TIME-	power-off of the con-
61	PLC TIMEOUT 2	OUT 1 or 2 is displayed.	trol. In order to
		This message is generated in EMG state.	repair it, turn to a
			well-trained expert.
70	DPG TIMEOUT	If the interpolation cycle does not expire	This message can
		in the time slice reserved for it, message	only be canceled by
		DPG TIMEOUT is displayed.	power-off of the con-
		This message is generated in EMG state.	trol. In order to
			repair it, turn to a
			well-trained expert.
80	15V FAILURE	If the comparator circuit detects that the	This message can
		specified voltage is not available at the	only be canceled by
		+/–15V output of power supply, message	power off of the con-
		15V Failure is displayed.	trol. In order to
		This message is generated in EMG state.	repair it, turn to a
			well-trained expert.
90	SYNC. FAILURE 1	If the movement of two axes is synchro-	This message causes
		nized (gantry axes) and the position	EMG state and loss
91	SYNC. FAILURE 2
		deviation value of the two axes is larger	of reference point. It
		than the value set at parameter, message	can be canceled by
92	SYNC. FAILURE 3
		SYNC. FAILURE n is displayed.	RESET.
93	SYNC. FAILURE 4	n=1...8 refers to the number of synchronic
		axes.
94	SYNC. FAILURE 5	This message is generated in EMG state.
95	SYNC. FAILURE 6
96	SYNC. FAILURE 7
97	SYNC. FAILURE 8
100	SHORT 000	If an interface output line is short-	This message causes
		circuited or overloaded, message SHORT	EMG state and loss
120	SHORT 020
		ijk is displayed, where:	of reference point. It
200	SHORT 100	i=0 means the 1st, i=1 the 2nd, i=2 the	can be canceled by
		3rd and i=3 the 4th interface card and j=0	RESET.
220	SHORT 120	means the first, while j=2 means the sec-
		ond 16 output lines on the interface card.
300	SHORT 200
		The short-circuited output line is not iden-
		tified more exactly, k is always 0.
320	SHORT 220
		This message is generated in EMG state.
400	SHORT 300
420	SHORT 320

124