NCT Group NCT 2000T, NCT 100T, NCT 990T manual 131

14.3 Listing of Global Messages

Error	Message		Description	Canceling and Re-
Code				pairing Method
3018	,A IN G2, G3		If in circular interpolation block (G2, G3)	The message is can-
			angle (,A) has been programmed.	celed by RESET
				key.
3019	D O M I N A T O R C O N -		If in 3D radius compensation calculation	The message is can-
	STANT=0		the value of dominator constant is 0.	celed by RESET
				key.
3020	DATA DEFINITION	ER-	If in block G33, G34	The message is can-
	ROR G33,G34		more than 2 axes have been programmed,	celed by RESET
			or	key.
			both E and F are filled out, or
			the thread lead is 0, or
			,C or ,R has been programmed.
3021	G51 IN G33		If in block G33 scaling (G51) is on.	The message is can-
				celed by RESET
				key.
3022	DIVIDE BY 0 IN G33		If G33 has been programmed and	The message is can-
			value E is less than or equal with 0, or	celed by RESET
			the pulse number of spindle encoder on	key.
			parameter 5023 ENCODERS1 is 0.
3023	DATA DEFINITION	ER-	In block G26 an address not interpreted	The message is can-
	ROR G26		has been specified or there is a value	celed by RESET
			specification error at an interpreted ad-	key.
			dress.
3024	ERRONEOUS P VALUE IN		If in block G96 (programming constant	The message is can-
	G96		surface speed) value P is not 1...9.	celed by RESET
				key.
3025	DEFINITION ERROR S		If programmed spindle revolution (S) is	The message is can-
			greater than 65000 or	celed by RESET
			negative or	key.
			in canned cycles G84.2, G84.3 equals to
			0.
3026	DEFINITION ERROR G10		If in block G10 L3 (filling up the life time	The message is can-
	L3		table) P or L are in one block under ad-	celed by RESET
			dress T, H or D or other address was pro-	key.
			grammed.
3027	DEFINIT. ERROR T	IN	If in block G10 L3 (filling up the life time	The message is can-
	G10 L3		table) address T is defined without a	celed by RESET
			group being referred to.	key.
3028	MORE TOOLS IN G10 L3		If in block G10 L3 (filling up life time ta-	The message is can-
			ble) the number of tools within a group	celed by RESET
			exceeds the maximum value registered on	key.
			parameter 1181 GROUPNUM.

131