NCT Group NCT 2000T, NCT 100T, NCT 990T manual 128

14.3Listing of Global Messages

Error	Message	Description	Canceling and Re-
Code			pairing Method
1340	LIMIT t+	This message is displayed, if one of the	The error can be can-
		axes has run on limit switch or on overtra-	celed only by moving
1341
		vel position specified at a parameter in	the axes away from
		direction –.	the overtravel posi-
1342
		Value of t is the name of the axis: X, Y,	tion by means of
1343		Z, U, V, W, A, B, C.	manual intervention.
		In the error code (1360, 1361, 1362, ...)
1344		the digit on local value 1 (0, 1, 2, ...) +1 is
		the physical axis number.
1345
1346
1347
1360	LIMIT t–	This message is displayed, if one of the	The error can be can-
		axes has run on limit switch or on overtra-	celed, only by mov-
1361
		vel position specified at a parameter in	ing the axes away
1362		direction –.	from the overtravel
		Value of t is the name of the axis: X, Y,	position by means of
1363		Z, U, V, W, A, B, C.	manual intervention.
		In the error code (1360, 1361, 1362, ...)
1364
		the digit on local value 1 (0, 1, 2, ...) +1 is
		the physical axis number.
1365
1366
1367
1380	SPINDLE LOOP OPEN	This message is displayed, if spindle in-	The message is can-
		dexing has been commanded on address C	celed by RESET
		or by M function and orientation M19 has	key.
		not been programmed previously.
1400	INTERNALLY FORBID-	This message is displayed by the NC, if an	The error can be can-
	DEN AREA	internally forbidden area has been speci-	celed only if the axes
		fied by means of command G22, and one	are moved away from
		of the axes runs on the limit of this area,	the zone limit by
		or is in the forbidden area at the moment	means of manual
		of specification.	intervention. If in the
			moment of selection
			one of the axes is in
			the forbidden area,
			first the specification
			must be canceled by
			means of command
			G23.

128