NCT Group NCT 100T, NCT 990T, NCT 2000T manual 132

14.3Listing of Global Messages

Error	Message	Description	Canceling and Re-
Code			pairing Method
3029	GROUP NUMBER IS TOO	If in block G10 L3 (filling up life time ta-	The message is can-
	HIGH	ble) the number of tool groups exceeds the	celed by RESET
		maximum value registered on parameter	key.
		1181 GROUPNUM.
3030	DEFINITION ERROR T	If tool call is being programmed (address	The message is can-
		T) and value T is greater than 9999, or is	celed by RESET
		negative.	key.
3031	ALL TOOL LIVES ARE	If, in case of tool selection, all tool lives	The message is can-
	OVER	within the group referred to (address T)	celed by RESET
		has expired.	key.
3032	CONFLICTING M CODES	If conflicting M codes have been program-	The message is can-
		med.	celed by RESET
			key.
3033	DEFINITION ERROR M	If M function is being programmed and	The message is can-
		the value, written under the address, is	celed by RESET
		greater than 999 or is negative.	key.
3034	DEFINITION ERROR A,B,C	If address A, B or C is specified as func-	The message is can-
		tion and its value is greater than 65000.	celed by RESET
			key.
3035	DEFINITION ERROR P	If dwell is being programmed (G4 or	The message is can-
		canned cycle) and value P is greater than	celed by RESET
		105, or is negative,	key.
		if in block G4 address P is not filled out ,
		if in block G5.1 or G10 it is filled out
		incorrectly.
3036	G39 CODE IN G40	If block G39 is programmed in state G40	The message is can-
		or in 3D tool radius compensation mode.	celed by RESET
			key.
3037	G39 NOT IN G1,G2,G3	If block G39 is programmed and the	The message is can-
		previous block is not G1, G2 or G3.	celed by RESET
			key.
3038	DEFINITION ERROR Q	In case of intersection calculation has not	The message is can-
		been specified on address Q which inter-	celed by RESET
		section is to be calculated,	key.
		in G70, G71, G72, G73 turning cycles the
		end block number of the profile has not
		been specified,
		in the G76 multiple thread cutting cycle
		the first cut specified on Q is not
		interpretable.
3039	G38 CODE IN G40	If a vector hold block (G38) is	The message is can-
		programmed in state G40 or in 3D tool	celed by RESET
		radius compensation mode.	key.

132