NCT Group NCT 2000T, NCT 100T, NCT 990T manual Graphic Position Screens

3.5GRAPHIC POSITION Screens

Down (PgDn). By means of softkeys, as well as the page keys the drawing area can be halved or doubled. As the effect of Full Sceen action the centre of the screen automatically adjusted to the middle of the tool path and scaling is set that the tool path covers the whole screen.

Graphic Action Menu: After pushing the softkey the following actions appear: Auto Erase, G40, G53, Dotted. Using Auto Erase the item with the same title in graphic parame- ters table can be set or reset. Its effect detailed above. The softkey G40 can only be used in case of running in TEST mode. In its switched-on state the drawing appears on the screen without tool radius compensation. In the pushed in state of button G53 drawing is done in machine coordinate system instead of the actual work coordinate system, that is if more coordinate systems are used in the same program the tool path can be seen separetely. In the pushed in state of button Dotted the separate points are not connected together with lines. It is useful when the program consists of small minute lines.

Refresh action: The operation clears the screen and draws the tool path again.

Window Action menu: After using this key a frame appears on the screen. This frame can be shrinked onto a detail of tool path with function keys appearing on soft keys or cursor and paging keys the way as they are used in Move and Zoom operations. After paging out of this action group the detail assigned by the frame is drawn onto the screen.

44