NCT Group NCT 990T, NCT 100T, NCT 2000T manual 133

14.3 Listing of Global Messages

Error	Message		Description	Canceling and Re-
Code				pairing Method
3040	G38 NOT IN G0, G1		If vector hold block G38 was programmed	The message is can-
			and the interpolation code is not G0 or	celed by RESET
			G1.	key.
3041	AFTER G2,	G3 ILLEG.	If in offset mode (G41, G42) an offset	The message is can-
	BLOCK		mode cancel block (G10, G20, G21, G22,	celed by RESET
			G23, G28, G29, G30, G31, G37, G52,	key.
			G53, G54, ..., G59, G92) is programmed
			after circular interpolation block.
3042	G40 IN G2, G3		If offset mode was going to be canceled in	The message is can-
			mode G2 or G3:	celed by RESET
			G40 G2 X Y R.	key.
3043	G41, G42 IN G2, G3		If start-up of offset mode was going to be	The message is can-
			performed in mode G2 or G3:	celed by RESET
			G40	key.
			G41 G2 X Y R.
3044	G41, G42	DEFINITION	If offset mode is turned on for the duration	The message is can-
	ERROR		of one movement block:	celed by RESET
			G40...	key.
			G41 X Y
			G40 X Y.
3045
3046	NO INTERSECTION G41,		If in offset mode (G41, G42) point of	The message is can-
	G42		intersection cannot be determined between	celed by RESET
			the current and next movement block.	key.
3047	CHANGE NOT POSSIBLE		If in offset mode (G41, G42) the direction	The message is can-
			change (G41 º G42 or G42 º G41) is	celed by RESET
			not feasible even by relocation of the	key.
			circle center.
3048	INTERFERENCE ALARM		If in offset mode (G41, G42) interference	The message is can-
			alarm occurs.	celed by RESET
				key.
3049	CIRCLE ARC TOO LONG		If the arc of a circle (G2, G3) is too long.	The message is can-
				celed by RESET
				key.
3050	NO REFRNC POINT G29,		If no reference point return has been done	The message is can-
	G30		on axes programmed in the block when	celed by RESET
			executing command G29 or G30.	key.

133