NCT Group NCT 990T, NCT 100T, NCT 2000T manual 139

			14.3 Listing of Global Messages
Error	Message	Description		Canceling and Re-
Code				pairing Method
3123
3124
3125
3126
3127
3500	PROGRAM EDITED	This message is displayed, if program se-		The message is can-
		lected for automatic execution is edited in		celed by RESET
		automatic mode, or		key.
		if program selected for manual data input		The program can be
		execution is edited in MDI mode,		started if the EDIT
		meanwhile START is pressed.		screen is closed after
				terminating editing.
3502	BAD BAUD RATE VALUE	If not standard baud rate value or a baud		The message is can-
		rate that cannot be interpreted by control		celed by RESET
		is set at parameter 2002 BAUD RATE. It		key.
		is displayed in DNC mode. The values
		interpreted by the control are listed in the
		description of parameters.
3503	SERIAL BUFFER FULL	If the serial buffer has been overrun in the		The message is can-
		course of DNC machining.		celed by RESET
				key.
				Data transfer must be
				restarted.
3504	TOOL PLACE TABLE BAD	If NC finds the check sum of the tool pot		The message is can-
		table false.		celed by RESET
				key.
				Tool pot table must
				be reorganized.
3505	N O T E X I S T I N G	If a program had been selected for auto-		The message is can-
	PROGRAM	matic or MDI execution, than the program		celed by RESET
		was deleted and without selecting a new		key.
		program START is pressed in automatic
		or MDI mode.
3507	OVERWRITE (Y/N)	If the program being executed loads pro-		If the old program is
		gram to the control memory by means of		to be overwritten key
		command DPRNT, with the number of		Y must be pressed,
		which a program has already been regis-		otherwise key N or
		tered in the directory.		RESET.

139