NCT Group NCT 2000T, NCT 100T, NCT 990T manual 125

14.3 Listing of Global Messages

Error	Message	Description	Canceling and Re-
Code			pairing Method
999	SHORT MON	This message is displayed, if MON (Ma-	This message causes
		chine ON) output of control is short-cir-	EMG state and loss
		cuited or overloaded.	of reference point. It
		This message is generated in EMG state.	can be canceled by
			RESET.
1020	POSITION ERROR	This message is displayed, if the position	The message is can-
		lag does not reach the value specified at	celed by RESET
		parameter within 5 seconds after the	key. In order to
		interpolator has stopped. The above detec-	repair the cause of
		tion is executed in case of command G00	error, the input
		if parameter 1241 POSCHECK is 1, or in	offsets of the drives
		case of feed movement in states G9 and	must be zeroed.
		G61.
1100	REFERENCE POINT t1	This message is displayed, if the reference	The message is can-
		point switch has not been found within the	celed by RESET
1110
		distance specified at parameter REFDIS	key.
1120		(or if it cannot stop within that distance).
		Value of t is the name of the axis: X, Y,
1130		Z, U, V, W, A, B, C.
		In the error code (1100, 1110, 1120, ...)
1140
		the digit on local value 10 (0, 1, 2, ...) +1
		is the physical axis number.
1150
1160
1170
1101	REFERENCE POINT t2	This message is displayed if it cannot run	The message is can-
		off the switch within the distance	celed by RESET
1111
		specified at parameter SWLENGTH.	key.
1121		Value of t is the name of the axis: X, Y,
		Z, U, V, W, A, B, C.
1131		In the error code (1101, 1111, 1121, ...)
		the digit on local value 10 (0, 1, 2, ...) +1
1141
		is the physical axis number.
1151
1171

125