NCT Group NCT 100T, NCT 990T, NCT 2000T manual 135

				14.3 Listing of Global Messages
Error		Message	Description		Canceling and Re-
Code					pairing Method
3059
3060
3061
3062
3063
3064	BAD	MACRO STATE-	If the macro expression is syntactically		The message is can-
	MENT		incorrect.		celed by RESET
					key.
3065	TOO LONG BLOCK		If the programmed block does not have		The message is can-
			enough room in the buffer.		celed by RESET
					key.
3066	N O I N T E RSEC T I O N		If there is no intersection point (eg., in		The message is can-
	POINT		case of parallel straights lines, concentric		celed by RESET
			circles etc.), when executing intersection		key.
			point calculation.
3067	FAULTY ,A IN G16		If there is no end position in case of refer-		The message is can-
			ring to address ,A when specifying polar		celed by RESET
			coordinate data.		key.
3068	FAULTY READ		If a false sector is read from memory dur-		The message is can-
			ing program execution.		celed by RESET
					key.
3069	LEVEL EXCESS		This message is displayed in case		The message is can-
			the permissible depth of subprogram is		celed by RESET
			over 8 or		key.
			that of the macro is over 4.
3070	NOT	EXISTING BLOCK	If reference is made to a block number not		The message is can-
	NO. P, Q		specified in instruction M99 P, GOTO or		celed by RESET
			in G70, G71, G72, G73 turning cycles.		key.
3071	MISSING OR FAULTY P		If, in case of subprogram call (M98 P) or		The message is can-
			macro call (G65 or G66 or G66.1 P),		celed by RESET
			address P is not filled out, or		key.
			P is greater than 9999, or
			P is negative.
3072	DEFINITION ERROR L		If at address L repetition count (M98 P L,		The message is can-
			G65 P L, or in case of a canned cycle) has		celed by RESET
			been programmed, or L was used in com-		key.
			mand G10, and L is greater than 65000.

135