Panasonic WJ-SX150A manual 146, NON-PANASONIC Models PS·DATA

TIME-LAPSE VCR CONTROL

MUX

[NON-PANASONIC MODELS] (PS·DATA)

A time-lapse VCR is operable with the system controller, while connecting to the matrix switcher.

Notes:

•The same descriptions as the system controller’s operating instructions are not mentioned here. Refer to them.

•Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the digital disk recorder, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and time-lapse VCR's SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 47 Connection with the Time-lapse VCR (Non-Panasonic Models), p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79 WJ-SX150A ADMINISTRATOR CONSOLE.]

•You cannot control non-Panasonic time-lapse VCRs from PS·Data system controllers.

The following is the procedure of a non-Panasonic model time-lapse VCR.

■Controlling the Time-lapse VCR with a PS·Data System Controller

●Manual Recording

Refer to the time-lapse VCR’s operating instructions for how to operate.

●Normal Playback

1.Enter the recorder mode. (Refer to p. 141.)

2.Do the playback procedure using the buttons on the front panel of time-lapse VCR. (Refer to the time-lapse VCR’s operating instructions for how to operate.)

3.Press the VCR/CAM button. The playback image will appear on the monitor.

4.To display the spot picture, press the numeric buttons corresponding to the desired camera number, then press the CAM [SET] button. Then, the active monitor number with “-H**” (** is logical the camera number)” will appear on the LED display. (Refer to p. 132 Normal Playback for the illustration.)

●Other Operations

Refer to the time-lapse VCR’s operating instructions for how to operate.

146