Panasonic WJ-SX150A manual Time-Lapse Vcr Control, Controlling the Time-lapse VCR, Normal Playback

TIME-LAPSE VCR CONTROL

MUX

[NON-PANASONIC MODELS] (TERMINAL MODE)

A time-lapse VCR is operable with the system controller, while connecting to the matrix switcher.

Notes:

•Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the digital disk recorder, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and time-lapse VCR's SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 47 Connection with the Time-lapse VCR (Non-Panasonic Models), p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79 WJ-SX150A ADMINISTRATOR CONSOLE.]

•You cannot control non-Panasonic time-lapse VCRs from system controllers.

The following is the procedure of a non-Panasonic model time-lapse VCR.

■Controlling the Time-lapse VCR

●Multiscreen Segment Switching

The operations are the same as WJ-HD500 Series. Refer to p. 131 Multiscreen Segment Switching.

Note: 7-, 10-, and 13- segment multiscreen display are unavailable.

●Normal Playback

1.Enter the recorder mode. (Refer to p. 131 Recorder Mode.)

2.Do the playback procedure using the buttons on the front panel. (Refer to the time-lapse VCR’s operating instructions for how to operate.)

3.Press the PLAY button. The playback image will appear on the monitor.

4.To display the spot picture, press the numeric buttons corresponding to the desired camera number, then press the CAM [SET] button. Then, the active monitor number with “-H**” (** is the logical camera number)” will appear on the LED display. (Refer to p. 132 Normal Playback for the illustration.)

●Other Operations

Refer to the time-lapse VCR’s operating instructions for how to operate.

140