Panasonic WJ-SX150A manual Precautions, Document Convention

PRECAUTIONS

•Refer all work related to the installation of this product to qualified service personnel or system installers.

•Do not block the ventilation opening or slots on the cover.

To prevent the appliance from overheating, place it at least 5 cm (2 inches) away from the wall.

•Do not drop metallic parts through slots.

This could permanently damage the appliance. Turn the power off immediately and contact qualified service personnel for service.

•Do not attempt to disassemble the appliance.

To prevent electric shock, do not remove screws or covers.

There are no user-serviceable parts inside. Contact qualified service personnel for maintenance.

•Handle the appliance with care.

Do not strike or shake, as this may damage the appli- ance.

•Do not expose the appliance to water or moisture. Do not try to operate it in wet areas.

Take immediate action if the appliance gets wet. Turn the power off and refer servicing to qualified service personnel. Moisture can damage the appliance and also cause electric shocks.

•Do not use strong or abrasive detergents when cleaning the appliance body.

Use a dry cloth to clean the appliance when it is dirty. When the dirt is hard to remove, use a mild detergent and wipe gently.

•Do not operate the appliance beyond its specified temperature, humidity, or power source ratings.

Use the appliance at temperatures within –10 °C - +50 °C (14 °F - 122 °F) and humidity below 90 %.

The input power source for this appliance is 120 V AC, 60 Hz.

•We recommend that you note down your settings and save them. Power or battery failure may erase the settings you enter.

DOCUMENT CONVENTION

This operating instructions use the following convention when describing the use and operation of this unit.

Unit: Panasonic Matrix Switcher WJ-SX150A

Multiplexer board : Panasonic Multiplexer Board WJ-SXB151 MUX

System controller: Panasonic System Controller WV-CU360C or WV-CU360CJ

Recorder: Panasonic Digital Disk Recorder or a time-lapse VCR* (*Available only when the Multiplexer board is installed)

Receiver: Panasonic Indoor Receiver WV-RC100 or Outdoor Receiver WV-RC150

System: Surveillance control system

Master recorder: Recorder connected to the Master unit in a master-slave connection

Slave n* recorder: Recorder connected to Slave n unit in a master-slave connection

* n is a unit number.

Notes:

•Text with this appearance is a special instruction, rule, or side comment related to the topic.

•In these operating instructions, WV-CU360C is used for the illustrations and descriptions of the system controller.

Symbol Used in The Operating Instructions

These operating instructions use the icon shown below to describe the functions available when the Multiplexer board is installed in the unit.

MUX : Functions available with the Multiplexer board

7