•NORMAL
EXT.: Select this to
002,004 to 255 (field): Select one of these normal recording rates if the asynchronous unit is connect- ed to the unit.
The factory default setting is EXT.
•DYNAMIC REC
PRI.: Select this to give recording priority to the camera channel with the alarm input.
ONLY: Select this to record the images from the alarm- associated camera channel.
GROUP: Select this to give recording priority to a group of up to 4 camera channels associated to the alarm input.
OFF: Select this to deactivate the alarm priority mode.
The factory default setting is OFF.
•DUMMY BLACK
ON: Select this to display the black picture for a camera channel that is not connected to the camera.
OFF: Select this to skip the camera channels that are not connected to the camera in the sequence/spot mode.
The factory default setting is ON.
•CAM SW LOSS
ON: Select this to make “CAMSW LOSS R∗” light up on the associated monitor when loss of the camera switching pulse is detected.
OFF: Select this not to make “CAMSW LOSS R∗” appear on the associated monitor when loss of the camera switching pulse is detected.
The factory default setting is ON.
Note: If EXT. is selected for 910 ALARM/920 NORMAL, the playback images cannot be displayed on the monitors which are not connected to the EXT IN connector. Confirm the images on those which are connected to the recorder.
■MUX CAMERA TITLE MUX
1000 MUX CAMERA TITLE
SWITCHER=SLAVE1(1 of 3)
CAM LCN | TITLE | CAM LCN | TITLE | ||
1 | 1 | C01 | 9 | 09 | C09 |
2 | 2 | C02 | 10 | 10 | C10 |
3 | 3 | C03 | 11 | 11 | C11 |
4 | 4 | C04 | 12 | 12 | C12 |
5 | 5 | C05 | 13 | 13 | C13 |
6 | 6 | C06 | 14 | 14 | C14 |
7 | 7 | C07 | 15 | 15 | C15 |
8 | 8 | C08 | 16 | 16 | C16 |
LCN:LOGICAL CAMERA NUMBER
●How to Display
To display this menu on the monitor, move the cursor to 1000 MUX CAMERA TITLE in SETUP MENU by moving the joystick to D or C. Then, press the CAM (SET) button. The submenu appears on the monitor.
●How to edit
The factory default settings are same as the illustration.
The editing procedure is the same as 500 CAMERA TITLE. (Refer to p. 71.)
Notes:
•Up to 8 alphanumeric characters are available for each Multiplexer board camera title.
•When moving the joystick to D at the last text box of CAM 8 TITLE, the cursor will move to the first text box of CAM 9 TITLE.
•When moving the joystick to C at the first text box of CAM 9 TITLE, the cursor will move to the last text box of CAM 8 TITLE.
•If five units are connected in the system, you can configure no parameters for MASTER.
78
