■Tour Sequence
This window configures the parameters of tour sequences: the operating camera, dwell time*, preset position** in each step.
Each sequence has up to 64 steps, and up to 32 sequences are configurable.
The configuration of a tour sequence can be copied to another one.
*the display time of a camera image
**the panning/tilting position which has been preset in advance
Notes:
•Enter the parameters from Step 1 in a sequential order. If you skip a step, it will result in an error.
•After selecting a camera number, be sure to select the dwell time, too. If you skip either of them, the message requesting the parameter entry will appear.
●How to Display
1.To display this window, click on the 
(Tour
Sequence) button in the main window (p. 80). Or click
on the 
(Tour Sequence) button in the Group Sequence window.
2.To select Tour 1 to 32, click on a desired
3.After configuring 16 steps, click on a tab followed by next 16 steps.
●Parameters
LCN
Selects the operating camera in each step.
The camera is selectable from LCN 1 to 99. After selecting LCN, select the time for Dwell.
Note: Configure Step 1 to the last step in a sequential order. If there is a skipped step whose LCN and/or Dwell is “-
Preset
Selects the preset position of the operating camera. The preset position is selectable from Preset 1 to 64.
Note: Refer to p. 109 Program Preset Position for details of how to program preset positions.
Dwell
Selects the dwell time of the operating camera.
The dwell time is selectable from 1 to 30 seconds (by a second). Set
(DELETE) button
Deletes the configuration of all the steps of the selected tour sequence.
(COPY) button
Copies the configuration of all the steps of the selected tour sequence to the another tour.
(PASTE) button
Pastes the cut or copied configuration to another tour sequence.
(Save Exit) button
Saves the configuration and closes the Tour Sequence win- dow.
(Cancel Exit) button
Cancels the configuration and closes the Tour Sequence window.
84
