Panasonic WJ-SX150A manual Logical Camera Number, Slave, CAM 1 to

•Slave

Slave units and connected recorders are displayed. To activate/deactivate Slave units, click the ON/OFF button of a desired Slave unit. When Slave units are set to ON, their unit names become selectable in SETUP MENU to config- ure the parameters.

(Save Exit) button

Saves the configuration and closes the Master-Slave win- dow.

(Cancel Exit) button

Cancels the configuration and closes the Master-Slave win- dow.

Notes:

•If you configure the master-slave composition, settings concerning LCN (logical camera number) and Multiplexer Title (refer to p. 100) will be changed. When you click on the Save Exit button, a message window will appear to confirm you the change.

•In WJ-SX150A Administrator Console, camera channels of the Master unit which are connected to MONITOR OUT 1/2/3/4 of Slave units are displayed in gray. You cannot configure the parameters.

■Logical Camera Number

This window configures logical camera numbers assigned to camera channels of each unit. During operation, logical camera numbers are used for camera control and monitor display.

To display this window, click on the (Logical Camera Number) button in the main window (p. 80).

●How to Display

•CAM 1 to 16

This stands for a camera channel of the unit.

•Logical Camera Number

Click on each drop-down menu to select a desired logical camera number. 1 to 99 is selectable. For camera channels without camera connections, select “- -“.

(Save Exit) button

Saves the configuration and closes the Logical Camera Number window.

(Cancel Exit) button

Cancels the configuration and closes the Logical Camera Number window.

Notes:

•If logical camera numbers are not selected, the cam- eras’ LCNs are not displayed in each window of SETUP MENU and WJ-SX150A Administrator Console.

•You can select a logical camera number for only one channel. When you select the same number more than one time, a message will appear. The message will noti- fy you that the number has been already used. If you click on “Yes”, the newer will be activated and the older will be changed to “- -“. If you click on “No”, the changed parameters will return to the former state.

•If five units (Master and Slave 1 to 5) are connected in the system, you cannot select logical camera numbers for Master.

82