Panasonic WJ-SX150A manual 139, Controlling the Time-lapse VCR, Fast-forward, Rewind

TIME-LAPSE VCR CONTROL

MUX

[PANASONIC MODELS] (TERMINAL MODE)

A time-lapse VCR (Panasonic Models) is operable with the system controller, while connecting to the matrix switcher.

Note: Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the time-lapse VCR, and con- figure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and time-lapse VCR's SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 46 Connection with the Time- lapse VCR (Panasonic Models), p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79 WJ-SX150A

ADMINISTRATOR CONSOLE.]

The following is the procedure of a Panasonic model time- lapse VCR.

■Controlling the Time-lapse VCR

The following are the operating procedures of the time- lapse VCR via system controllers.

●Multiscreen Segment Switching

The operations are the same as WJ-HD500 Series. Refer to p. 131 Multiscreen Display.

Note: 7-, 10-, and 13- segment multiscreen display are unavailable.

●Normal Playback

The operations are the same as WJ-HD500 Series. Refer to p. 131 Normal Playback.

Note: You cannot skip to the previous/next record.

●Fast-forward

1.Press the FF button to fast-forward the tape during the stop.

2.To stop fast-forwarding, press the STOP button.

Note: Pressing the FF button during fast-forward will start playback.

●Rewind

1.During the stop, press the REW button to rewind the tape.

2.Press the STOP button to stop rewinding.

Note: Pressing the PLAY button during rewind will start playback.

●Manual Recording

The operations are the same as WJ-HD500 Series. Refer to p. 132 Manual Recording.

●Stopping REC ONLY Alarm Recording

The operations are the same as WJ-HD500 Series. Refer to p. 132.

139