Panasonic WJ-SX150A manual Preparation, Unit Number Selection

Pattern 4: Master, Slave 1 to 4 are connected in the system.

Slave 1		Slave 2				Slave 3	Slave 4
Camera 1 to 16	Camera 17 to 32				Camera 33 to 48		Camera 49 to 64
HDR PSD D3 D2 D1 CAM	HDR	PSD D3 D2 D1 CAM			HDR	PSD D3 D2 D1 CAM	HDR PSD	D3	D2 D1 CAM
FS 16		FS 16				FS 16			FS 16
						Master
MON1→CAM1	MON1→CAM5						MON1→CAM9		MON1→CAM13
MON2→CAM2	MON2→CAM6						MON2→CAM10		MON2→CAM14
MON3→CAM3	MON3→CAM7						MON3→CAM11		MON3→CAM15
MON4→CAM4	MON4→CAM8						MON4→CAM12		MON4→CAM16
		HDR PSD	D3	D2	D1	CAM
							MONITOR OUT 1 to 4

PS•DataTerminal - mode

Note: Before connections, make sure all the units have the same firmware version. You can see the firmware version of each unit in SETUP MENU. (Refer to pp. 72 and 73 710 MASTER-SLAVE.) In case there is a version difference, update the firmware of each unit to the newest using a CD-ROM. (Refer to pp.58 to 60 FIRMWARE UPDATE.)

●Preparation

Prepare the following items besides standard accessories.

•Personal computer x 1 (Refer to p. 79 Platform for details on system requirements.)

•9-pin D-sub crossing cable x 1 (Used for connection between the PC and the Master unit)

•Phillips screwdriver x 1 (Used for opening the front panel and setting unit numbers)

•Coaxial cable* (Used for connection of the Master and Slave units)

•Cable Kit WV-CA48/10K* (Used for connection of more than one Slave unit)

*Necessary number will differ depending on the connection pattern.

●Unit Number Selection

Set the unit number selector of each unit to determine Master and slave n*. (Refer to the illustration and diagram in p. 24.) *n is a unit number.

52