Panasonic WJ-SX150A Rear View, 6 %7, Mode, 6Controller Number switch CONTROLLER No, 0Clamp

●Rear View

%6 %7

RISK OF ELECTRIC	9	0	1
			2
	8		3
SHOCK. DO NOT OPEN	7
	6	5	4
RISQUE DE CHOCS ELECTROUES	CONTROLLER No. MODE
NE PAS OUVRIR

%8 %9 ^0

DATA DC 9V IN

^1 DC 9V IN

%6Controller Number switch (CONTROLLER No.)

Selects a number for the system controller for identifica- tion in a system. Normally, set the switch to number 1.

9	0	1
8		2	#1
7		3
6	5	4

CONTROLLER No.

%7Mode Selection switches (MODE)

The operation mode of the system controller is selected with these switches.

When you use a terminal-mode system controller, set the switches to the positions shown in the figure.

OFF

ON

1 2 3 4 5 6 7 8

MODE

Note: When you use a PS·Data system controller, refer to the system controller's operating instructions.

%8Data ports (DATA)

Exchange the control data with the matrix switcher via RS-485 cable (supplied with the system controller).

%9DC 9V Input jack (DC 9V IN)

Use this jack to plug the AC adapter supplied with the system controller.

^0Clamp

Fastens the supplied AC adapter's power cord.

^1AC adapter

Caution: Use only the supplied AC adapter to feed 9 V DC to the system controller.

Note: Disconnect the plug from the controller before setting the controller number switch or mode selec- tion switch, and reconnect it when finished. The new settings will take effect when the power is turned on.

29