Panasonic WJ-SX150A manual Ps·Data, WJ-HD100 SERIES CONTROL, Recorder Mode

WJ-HD100 SERIES CONTROL

MUX

(PS·DATA)

This section will describe what you should take notice when using a PS·Data system controller.

The same descriptions as the system controller's operating instructions are not mentioned here. Refer to them.

Note: Before the use, it is necessary to install the Multiplexer board in the matrix switcher, connect the matrix switcher to the digital disk recorder, and configure the system through WJ-SX150A Administrator Console, OSD SETUP MENU, and WJ- HD100 Series SETUP MENU. [Refer to p. 32 Installing the Multiplexer Board, p. 45 Connection with Digital Disk Recorder WJ-HD100 Series, p. 63 WJ-SX150A SETUP MENU (OSD), p. 79 WJ-SX150A ADMINISTRATOR CONSOLE, and p. 137 Displaying WJ-HD100 Series SETUP MENU.]

■Controlling the Recorder with a PS·Data System Controller

●Recorder Mode

1.Enter the recorder mode. (Refer to p. 141.)

2.Press the SHIFT button to activate the FUNCTION buttons.

3.Enter the desired function code, and then press the FUNCTION button. (Refer to the diagram.)

Function	Code	Note
Forward field advance	1
Backward field advance	2
To the last field	3
Pause	4
Playback	5
Recording	6	Equal to the REC button of the recorder
To the first field	7
Stop recording and playback	8
Stop playback	9	Exclusive use to stop playback
Stop recording	10	Exclusive use to stop recording
Search forward	11	Searching will speed up every time you enter the code.
Search backward	12	Searching will speed up every time you enter the code.

4.To select a camera channel, press the numeric button(s), then CAM button. The system will exit from the recorder mode, and the selected camera image will be displayed on the monitor.

Notes:

•Only one operator can enter the recorder mode.

•The images from the recorder, which are displayed on the monitor, is conformed to the recorder setting.

●Stopping REC ONLY Alarm Recording

The operations are the same as WJ-HD500 Series. Refer to p. 142.

144