■Error List
The following error messages are displayed through SX150 Program Writer.
●File Error
This error message is displayed during the following occa- sions.
•You have selected a wrong file (whose file extension is not “. mot”) in Step 13 of p. 59.
•The “.mot” file is broken.
To solve this problem, select the correct file. (Refer to p. 59.)
●Not Ready
This error message is displayed when the matrix switcher’s mode is not “SX150 SOFTWARE UPLOAD”.
To solve this problem, do the following.
1.Power off the matrix switcher.
2.Set the mode selector of the matrix switcher to “SX150 SOFTWARE UPLOAD”. (Refer to p. 24.)
3.Power on the matrix switcher again.
●Timeout Error
This error message is displayed when a specified time has passed since you started installing SX150A Program Writer/updating the firmware. The following are the timeout error statuses.
Status 0: 30 seconds has passed since the PC became idle.
Status 1: 30 seconds has passed since the
Status 3: 20 minutes has passed since the file transfer was started.
Status 4: 30 seconds has passed since the file transfer was completed.
Status 5: 30 seconds has passed since the file loading became OK.
Status 6: 5 seconds has passed since the file erasing is started.
Status 7: 5 seconds has passed since the file writing is started.
60
