Panasonic WJ-SX150A manual Low

1.Move the cursor with the joystick to the desired area, and then press the CAM (SET) key. Setting point 1 is determined.

Note: If you control the joystick while holding down the SHIFT button, the cursor will move by 10 steps.

C01 LOW

+

C01 LOW

+

Setting point

Logical camera number and sensitivity level will move when a cursor points here. (The default position is here.)

2.Move the “+” mark to the desired area, and then press the CAM (SET) key. Setting point 2 is determined and the “+” mark will disappear. Then, the mark will appear again at the center of the monitor. The square, covered with Setting point 1 and 2, is showing the motion-detec- tion area.

Note: White images will be displayed in the square if the currently selected channel has no camera connection.

C01 LOW

Setting point 2

+

Setting point 1

Notes:

•If you repeat Step 1 after setting 4 motion-detection areas, “NG” will blink at the center of the monitor for two seconds.

•To reset a motion-detection area, move the “+” mark on the desired area. Then, press the CLEAR button. The area will be reset.

•If an area overlaps another one, the newer area will be reset.

5.To configure the motion-detection areas of another camera channel, press the NEXT or PREV button.

6.Repeat Step 1 to 4.

Notes:

•If you press the CLEAR button while holding down the SHIFT button, all the motion-detection areas of the cam- era channel will be cleared.

•Depending on the sensitivity level, a motion-detection area needs the following area sizes.

Sensitivity	Area size
LOW	17 x 17 steps or more
MID	12 x 12 steps or more
HIGH	5 x 5 steps or more

You can change the sensitivity level in WJ-SX150A Administrator Console (Refer to p. 89.) The factory default setting is LOW.

After the configuration, press the MON (ESC) button. The motion-detection setting will be memorized and the monitor display will return to the previous menu.

After all the configurations, press the SETUP button while holding down the SHIFT button. The configuration will be updated when closing SETUP MENU.

3.To configure more motion-detection area, repeat Step 1 and 2.

4.To set the motion-detection area of another camera, press the NEXT or PREV button. Then, select the desired logical camera number. The live image of the selected camera will be displayed.

70