Panasonic WJ-SX150A manual Log-In And Log-Out, Log-in

LOG-IN AND LOG-OUT

Before starting the following procedures, all system compo- nents must be turned on.

The following procedures are applicable when the system controller is connected to the unit.

■Log-in

This operation is skipped when the auto log-in is set to ON. (Refer to p. 92.)

1.Turn on the power switches of all system components. The OPERATE indicator will light up.

2.To turn on the power of the system controller, connect the AC adapter to the AC outlet.

The LINK indicator lights up and "NO USER" appears on the LED display of the system controller.

3.To select your registered operator ID number (1 to 16, up to 2 digits), press the numeric buttons, then press the CAM (SET) button.

The underline appears on the LED display of the con- troller.

The factory default setting is 150.

Note: If an operator ID or password error occurs, the PROHIBITED indicator on the controller will blink and "NO ACC" will blink on the LED display for about 3 seconds. Then "NO USER" appears on the LED display. Return to Step 3 and select your oper- ator ID.

Note: If the auto log-in is set to ON, any operator can login automatically. After the controller is turned on, "AUTO" appears on the LED display for approximately 2 sec- onds, then "READY" automatically appears.

T&D	CAM ID	EVENT
STILL	AUX1 OFF	AUX1 ON
MON STATUS	ALL
EL-ZOOM	AUX2 OFF	AUX2 ON
ALM H	VLD H	SYS S
SEQUENCE	DEF OFF	DEF ON
MON (ESC)		CAM (SET)
MON LOCK	MULTI SCREEN SEL	WIPER

4.To select your registered password (up to 5 digits), press the numeric buttons, then press the CAM (SET) button.

The factory default setting is 150.

If the operator ID and password are correct, "READY" will appear on the LED display.

104