Paradyne 316x manual System Group, MIB, System Group ± ªsysDescrº Object system

SNMP MIB Objects

Transmission Supported on the T1 interfaces

Groupusing the DS1/E1 MIB. Supported on the synchronous DCE data ports using the RS-232-like MIB. Not supported on the COM and MODEM ports.

SNMP Group Supported.

System Group, MIB II

The System Group Objects are fully supported by the

T1 DSU/CSU. The following sections provide clarification for objects contained in the System Group where it is not otherwise clear how the object definition in MIB II is related to the DSU/CSU.

System Group ± ªsysDescrº

Object (system 1)

This object provides the full name and version identification for the systems hardware and software. Set this object to display the following string:

AT&T Paradyne T1 DSU/CSU, model xxxx-xx-xxx. S/W Release: yy.yy.yy. H/W CCA numbers: CCA1 zzzz.zzz CCA2 zzzz-zzz. Serial number ssssssss

Where: xxxx-xx-xxxrepresents the full model number of the unit.

yy.yy.yyrepresents the software revision number of the unit.

zzzz-zzzrepresents the hardware revision numbers for the unit.

ssssssssrepresents the serial number for

the unit.

System Group ± ªsysObjectIDº Object (system 2)

This object provides the authoritative identification of the network management subsystem contained in the unit. Set this object to display the following object identifier:

31601.3.6.1.4.1.74.1.14.2.2.1

31641.3.6.1.4.1.74.1.14.2.2.2

System Group ± ªsysUpTimeº Object (system 3)

This object provides the time in hundredths of a second since the network management subsystem contained in the unit was last re-initialized.

System Group ± ªsysContactº Object (system 4)

This object provides information about the contact person for the DSU/CSU.

System Group ± ªsysNameº Object (system 5)

This object provides the administratively-assigned name for the DSU/CSU.

System Group ± ªsysLocationº Object (system 6)

This object provides the physical location of the DSU/CSU.

System Group ± ªsysServicesº Object (system 7)

This object provides a value which indicates the set of services that are potentially offered by the DSU/CSU. Only the following values are supported by the DSU/CSU.

•physical(1) ± Layer 1 functionality for all interfaces.

•datalink/subnetwork(2) ± Layer 2 functionality (SLIP, PPP) for the COM and MODEM ports.

•internet(4) ± Layer 3 functionality (IP) for the COM and MODEM ports.

•end-to-end(8) ± Layer 4 functionality (UDP) for the COM and MODEM ports.

Therefore, set this object to 15 (the sum of 1 + 2 + 4 + 8).

3160-A2-GB22-10 December 1996 E-3